The Rego-Fix powRgrip® system uses a slightly tapered collet with a built-in set screw for presetting the tool.

It is pressed into the toolholder by means of a six ton precision hydraulic press.

To unclamp the tool the compression cycle is simply reversed. The clamping or unclamping cycles are very short, approx. 8 to 10 seconds.

After the clamping cycle the tool is immediately usable, no delay for cool down is necessary.

The powRgrip® system has a very high life expectancy.

Under normal operating conditions more than 20,000 clamping cycles are guaranteed:

- Highest transmittable torque and superior runout, even after 20�f000 tool changes
- Clamping in less than 10 seconds
- Clamps tool shanks down to O 3 mm
- Runout of . 0.003 mm
- Balanceable, just add the REGO-FIXR Balancing Rings . Can use coolant through tooling
- Tool presetting feature
- 1.7 times MRR (material removal rate) vs. Shrink-fit, according to tests conducted at the University of North Carolina at Charlotte